デニムを中心としたカジュアルウェア・ブランドUES(ウエス)

Care method of work boots

① Remove the dirt with a brush

First of all, remove the laces. Use a brush to carefully clean off the dirts and dusts.
You can apply the oil on the boots over-all after cleaning the dirts off.
→ UES recommend "Pig bristle HIRANO BRUSH ”

② Remove the old oil

It is better to use STAIN REMOVER to clean the old oil which is hard to be removed from your boots. It is recommended to use a piece of clean cloth with some STAIN REMOVER. To avoid any damage, do not rub it too hard.
→ UES recommend "STAIN REMOVER”

BOOTS FINISH

③ Put the oil on by hand

Apply the oil by hand would make it easier to melt the oil and penetrate to the surface of boots because of the body temperature.
"BOOTS FINISH" is a kind of oil UES recommend, which absorbed the advantages from MUSTANG PASTE and MINK OIL.
MUSTANG PASTE is 100% natural ingredients, it makes leather really soft.
Therefore, there is a risk that if the oil of MUSTANG PASTE penetrates too deep inside the leather of boots, it would make the strength of the work boots weaker.
Conversely, MINK OIL is likely to remain the oil on surface because of its toughness.
BOOTS FINISH will remain even moderately oil on the surface without too much penetration. Leave about half a day time after giving the oil, you can wipe off the excess oil. If you want to be make the boots softer, leave it 1 day.
MUSTANG PASTE cannot make the boots polished on the surface. MINK OIL take a high polish. In the case of BOOTS FINISH, leaving the boots for 1 day after applying oil, it would be fine polished because it contains a small amount of wax.
You can control the amount of BOOTS FINISH as you like.
→ UES recommend "Beckman original boots finish”

④ Brushing

After applying the oil, leave the boots for a period of time, and then remove the excess oil by brushing.
We recommend pig bristle brushes to clean work boots.
Pig bristle brush will absorb the oil after you used it every time.
As you continue to use, the brush will absorb the oil, and give the oil to the leather by daily care. Pig bristle brush is a very useful item which grows by itself.
→ UES recommend "Pig bristle HIRANO BRUSH ”

Timing to apply the oil

・When you feel leather is dry.
・After wearing in the rainy day(The oil on the boots would evaporated with water)
If the boots got wet in the rain, first of all, remove the shoelace, wipe off the moisture and dirt with a piece of clean cloth, please take care after drying at a airy place.

Timing to use a stain remover

・Once in two to three times after applied the oil
・If the dirt is already noticeable

PAGE TOP